Disclosure: This article is written by the official account of Water Detective (AtomBit). We also sell water quality test pens ourselves, so please read it with a critical eye.

Let's start with the conclusion: when looking at a water quality test pen, don't count the number of parameters; look at five things: whether it measures the key indicators, what principle it uses to measure, whether the wavelengths and names are standard, whether the stated range and accuracy are reasonable, and whether the data can be understood and retained. The "9 parameters" and the "9 parameters" may differ greatly.

First: Is there any "padding" among the parameters?

Divide common indicators into three tiers:

  • Key tier: turbidity, UV254—one is a routine indicator regulated by national standards, and the other is an organic-matter indicator commonly used in international water treatment.
  • Enhanced tier: COD, TOC—total organic matter.
  • Basic tier: TDS, conductivity, hardness, salinity, temperature—the first four of these are all closely related to conductivity, and are often several values converted from a single electrode.

If a pen with "9 parameters" has five or six items all in the basic tier, its effective information content is actually quite limited.

Second: Detection principle

PrincipleWhat it can measureWhat to pay attention to
Electrode (conductivity)TDS, conductivity, salinity; hardness can be convertedUnresponsive to organics and particles
Optical absorptionUV254, COD, TOC and other organic indicatorsWhether the wavelength is standard, whether the light source is stable
Optical scatteringTurbidityWhether there is an independent scattering channel
Single detector vs. dual detector—Dual detectors enable differential measurement, canceling out light source fluctuations and temperature drift

Third: check whether the wavelength and name are correct

UV254 is a clearly defined metric, specified in EPA Method 415.3 to be measured at 253.7 nanometers (optionally 254 nanometers). Some products on the market label other wavelengths such as UV275; the names look similar, but it is not the same metric, nor is it part of the above standard method system. In addition, metrics like "specific gravity" are of little significance for drinking water and are often used as filler.

Fourth look: range, accuracy, repeatability

  • The range must cover your scenario: COD in drinking water is generally a few mg/L, while water for raising fish may reach several tens.
  • Accuracy and resolution are not the same thing: a screen showing one decimal place does not mean it is accurate to one decimal place.
  • Repeatability is the most practical: measure the same cup of water several times in a row; the smaller the variation, the better it is for observing trends.

Fifth look: whether the data can be understood and retained

A monochrome screen only shows a single number or a single color, and many people do not know whether the result is good or bad after measuring. Pens without logging cannot retain readings after measurement, so trends cannot be observed.

What we do

Take Water Detective itself for comparison: it has both turbidity and UV254, with turbidity on a separate channel; the optical part uses dual-detector differential detection; the IPS color screen shows a radar chart, with each metric changing color individually; the mini program automatically logs data and provides AI interpretation. Our shortcomings are also written here: hardness is a value converted from conductivity, salinity is measured by the conductivity method with ordinary accuracy; it cannot measure pH and heavy metals. You can use this set of criteria to evaluate any pen, including ours.

References

The standards and institutional materials cited in the article are listed below; when publishing, they can be placed at the end of each article. Zhihu readers and AI both value verifiable sources more.